FAQ Of Ultrasonic Cleaning Device
Hagyjon üzenetet
How to distinguish positive and negative poles of ultrasonic transducer
A: The electrode between the two piezoelectric wafers is a positive electrode; Or the electrode piece and metal contact for the negative electrode.
How to connect the ultrasonic transducer
Answer: The parallel connection method is used. The wire needs to be perforated and wound and then tin welding. When using lap welding, it must be welded thoroughly so as not to burn out the ultrasonic transducer.
Selection of wire for connection of ultrasonic transducer
Answer: the positive electrode adopts 2.5 square high temperature resistant fiber line, and the negative electrode adopts 1.5 square high temperature resistant fiber line.
How are ultrasonic transducers insulated and tested
Answer: The exposed wire and tin welding parts shall be sealed by heat shrinkable casing and silicone coating.
How is insulation tested for ultrasonic transducers
A: Use a 1500V megohm meter to test the insulation resistance of the positive and negative terminals. The insulation resistance must be greater than 50M ω, except in high humidity environments.
Parameter order of ultrasonic transducer grouping
A: Generally grouped by frequency, capacitance and impedance.
Definition of ultrasonic transducer power
A: Ultrasonic cleaning transducer power, generally rated average power, refers to the maximum input power at the resonant frequency.
Definition of power of ultrasonic cleaner
Answer: The power of ultrasonic cleaning machine is generally the geometric product of the number of transducers and their rated power, known as nominal power. But the input power is lower than the nominal power.
Why is the input power lower than that of the cleaning machine
A: The power of a single ultrasonic transducer is the maximum power at its resonant frequency. When multiple ultrasonic transducers are in parallel, the total frequency after parallel connection should deviate from the resonant frequency of a single transducer for reasons such as the consistency of the transducer and the bonding process. The total input power is naturally lower than the nominal power of the cleaning machine when not working at the optimal frequency of each ultrasonic transducer. For a single drive circuit, the more parallel transducers, the greater the deviation.
Ultrasonic cleaning machine power selection
A: The power of ultrasonic cleaning machine generally depends on the size of the tank and the distribution of the transducer, usually calculated according to the power density of 0.5-0.6W /cm2.
How to arrange the transducer of ultrasonic cleaning machine
A: The arrangement of ultrasonic transducers depends on the structure of the water tank, considering the effective action distance of different frequencies, and then substitute the power density into the calculation and take the whole.
Why are there multiple frequencies in the debugging of ultrasonic cleaning machine
Answer: after ultrasonic transducer installation debugging machine, under the condition of strong electric field in the resonance point attachment has four frequency, the lower is the oscillator frequency of transverse vibration, next is the vibrator and the whole of stainless steel adhesion formation on the direction of vibration frequency, slightly lower than the natural frequency transducer, the third is the natural frequency of transducer, the fourth is to the frequency of vibration transducer microtek piece of radial. The second and third are available frequencies. In addition, when the circuit inductance is not well matched, there will be deviation from the frequency of vibration phenomenon.








